I think the issue is with the IPTV v1.9.71 SW causing it not to update through Android, but doing a SW Reset does not roll-back this to force a new IPTV update. I see other users with this same issue, at the moment I only have 1 box like this, I have over 120 boxes out there and fear this issue will cause me a lot of heartache if it cannot be resolved quickly. I can access the MTOL uninstall command in Menu/System/Android/Apps/MyTVOnline, but am afraid to do so because I have no way to find or get the APK or aptoid to load if I uninstall it. The box boots into "preparing to start" I sometimes see an "open vime from client" message flash up then it goes to the SW update page and shows 1 update to FW v2.8.71 from v2.8.13, the current IPTV version is v1.9.71.īy forcing it onto the red SYSTEM page (remove Internet) I can perform a factory and software reset, then reboot, but it still comes to the same page, I've also tried the Beta v2.8.70, but the same happens. So I've updated around 20 Z Nano boxes myself so far and had my clients perform their own too, but I had one today which has now gone into an update loop. Various bug fixes and performance improvements FIX: VOD Search not working with XC API portals FIX: Timeshift file is created on USB even if Timeshift is set to OFF FIX: Freeview HD EPG display issue when using USB DVB-T tuner FIX: Favorite channels disappear when using XC API FIX: Group Channel Numbering preference changes after applying Installer Mode config FIX: Cell overlap issue in Program Guide FIX: Page scrolling issue in TV Series section FIX: Favorite list changes if m3u list is updated FIX: Crashing issue when switching portals FIX: Episode playback issue on certain portals IMP: Increased refresh rate of detailed stream info FIX: Radio channel streaming issue on certain portals IMP: Improved front panel boot-up LED sequence FIX: System software update hangs when system memory is full IMP: Display resolution selection window only shows compatible resolutions FIX: Display Resolution button doesn't show resolution selection window Software cannot be rolled back after installation.
WARNING: Install and use at your own risk. (Excluding Z8)įirmware Version : 2.8.71 or 1.2.71 (Device dependent) Formuler Z-series official software released.
0 kommentar(er)
